General video · Level C1 - Part 2

How It's Made Magnets

Magnets attract certain metals and each other. That's handy for more than sticking stuff to the fridge.

Level: C1 · 52 sentences

Transcript

1. Magnets attract certain metals and each other.
2. That's handy for more than sticking stuff to the fridge.
3. They help run motors and generators, among other things.
4. Magnets occur in nature, but two centuries ago, people figured out how to make them using electricity.
5. You could say it was a take-charge situation.
6. You can't see or feel the force causing this globe to levitate,
7. but it's not magic, it's magnetic.
8. To make magnets, they must first create a sand mould of the magnet shapes.
9. They load this pattern of four magnet shapes into a machine that fills it with sand.
10. They remove the pattern and smooth the surface, dimpled by the machine's lid.
11. Then it's back inside, but this time the machine pumps in gases to chemically harden the sand.
12. It takes just seconds to solidify.
13. They lift out the sand slab, revealing the impression of the magnet pattern.
14. It's now a mould.
15. Magnets come in many shapes and sizes, as do their moulds.
16. Now they're ready to mould the magnet shapes.
17. They take copper, cobalt, sulphur, nickel, pure iron, aluminium and titanium.
18. They load all these metals into an electrical induction furnace.
19. It generates a pulsating electromagnetic field that heats to more than 1600 degrees Celsius,
20. melting everything into a molten soup.
21. They pour this into the sand moulds.
22. The moulds burst into flames because the gases that harden the sand are highly flammable.
23. They slide the blazing moulds to another part of the foundry and knock them to the floor.
24. Then they bust them open with a sledgehammer to get air inside so they cool down and the gases burn off.
25. They shovel everything into a bin
26. and sort the metal shapes from the sand chunks using, what else, a magnet.
27. The moulded pieces react like ordinary metal.
28. They don't yet have magnetic power.
29. Some are shaped like rings.
30. Threaded onto a copper pipe, they'll be used in electric motors.
31. They place the ring-covered pipe in a much larger tube.
32. Then they centre it by packing silica sand tightly around it.
33. The sand will hold the rings in position during the next step.
34. They seal both ends with concrete, allowing the inner copper tube to protrude slightly.
35. Then it's into a different electrical furnace.
36. It heats the tube full of magnet shapes until it's red hot.
37. This primes them to accept an electromagnetic field which will be delivered by this metal rod.
38. They slide it down the centre of the copper pipe and clamp it in place.
39. Water keeps the pipe from melting as they deliver a low-voltage, high-current charge in a cylindrical formation,
40. important for motor magnets.
41. They break open the seal.
42. The process has left the ring shapes mildly magnetized,
43. but most importantly, it's orientated the magnetic field properly.
44. They grind away any rough edges.
45. At this point, these magnets are pretty useless.
46. But this machine will empower them.
47. It delivers an electromagnetic charge to the metal which magnetises it.
48. The establishment of that weak magnetic field earlier has laid the groundwork for this moment,
49. ensuring that the magnetisation is properly orientated.
50. Now that's some serious magnetic muscle.
51. In their various forms, magnets continue to exert a lot of pull in our society,
52. because their invisible power helps keep so many things running.